How To Measure Torque Converter Bolt Pattern

How To Measure Torque Converter Bolt Pattern. On your flexplate, measure from the center of one bolt hole to the center of the center hole and multiply by 2. A stock converter stalls at about 1,700 rpm with a 350 sbc.

PTC TORQUE CONVERTER 9.5″ TURBO SPLINE LS1 PILOT from bluelineperformanceracing.com

Measure the distance between them, the 10 1/2 pattern should be 7 1/2 inches center to center and the 11 7/16 pattern should be 8in center to. The diameter of the circle on which the holes will be evenly distributed. If you have a th 400 converter that.

That Will Tell You The Diameter.

That’s your bolt circle diameter. In many ways, bayou city bolt is like the bolts we sell: Torque converters are sold by stall speed not their physical size as you can get a different stall in different size packages.

I Ran Into That When I First Dropped The 454 Into My Chevelle.

Are you sure its not from the closest edge? Get a piece of straight flat wood or a framing square and touch the side away from the wall and measure the distance between them. You can measure the bcd the same way on your converter (center of one hole to the center of the converter nose x2).

And Finally, The Torque Value For This Bolt Can Be.

You can measure the bcd the same way on your converter (center of one hole to the center of the converter nose x2). It was bolted to a 454. The 0° angle is to the right in the x axis and aligned with.

The Torque Converter Bolt Pattern Is 10, It's 13 In Diameter.

According the summit racing catalog most manufacturers list the same converter for th350 and th400. I got almost 5 1/2 from the middle which would be 11 inch but they only sell 10.5, 11.5 and 10 3/8 bolt pattern converters. In the same way we may calculate the following bolt pattern in inches, 5×5, to metric, which will be 5 times 25.4 = 127 (bolt pattern = 5×127).

For Example, The 10 Converter In My Race Car Measures Around 10 5/8 At Its Largest Point.the 8 Coverter I Ran In The Past Measured 8 3/4.

Built with integrity, completely reliable, and a fundamental part of operational stability. The diameter of the circle on which the holes will be evenly distributed. If you have a th 400 converter that.

Leave a Comment